1. Dear Guest, if you haven't already... enter to WIN Samplitude Pro X5!
    Dismiss Notice

Speaker went out

Discussion in 'Monitoring' started by Prophesi, Sep 10, 2016.

  • AT5047

    The New AT5047 Premier Studio Microphone Purity Transformed

  1. Prophesi

    Prophesi Active Member

    Sep 10, 2016
    I have a set of Samson A8 studio monitors. One day I heard static coming from one speaker. Every time a touched the volume knob on my audio interface I heard the sound. I still listened to music fine for two weeks. Today I opened pro tools to listen to music and I heard it more consistently and while the music was playing. All of a sudden the monitor completely stopped working. I checked wires and connections and the other one still works fine. Does anyone know why this happened
  2. Sean G

    Sean G Well-Known Member

    Jul 27, 2015
    Sydney, Australia
    Did you try swapping out the cable to the speaker?

    Did you try swapping over the speakers?...

    if the speaker still works when you swap it over...chances are its the interface.
  3. dvdhawk

    dvdhawk Well-Known Member

    Dec 18, 2008
    Western Pennsylvania, USA
    Cabling is always the first thing to check (power and audio).

    Do it have a pilot light? Is there power? Has the monitor's power cable come loose at either end? Is it plugged into a cheap generic powerstrip, or good rack mount power conditioner? Do the monitors have any external fuse or breaker?

    Definitely swap left/right audio cables as Sean G suggests. Observe any changes in behavior. It will be useful information to know whether the one working speaker still works plugged into the other output channel, and vice versa.

    If that doesn't get any results, then with the speakers turned off, and no music playing, you might try turning the volume knob on the interface from zero to 10 and back a dozen times. Do the same thing with the volume controls on the speakers. Then power things up and see if it behaves any differently. If a potentiometer sits in the same place all the time, it can build up oxidation or other crud on the path. Running the knob through its full range of motion (with nothing playing) may knock that crud loose and restore or improve contact.

    It's unlikely it's a raw speaker. Under normal circumstances, the woofer and tweeter aren't likely to both die at the same time unless there was catastrophic failure. (the kind that usually involves a small cloud of acrid smoke)

    Depending on your results, it might point to the interface's volume knob/potentiometer, the output connectors on the interface, the cables, a fuse or breaker in the monitor, the volume pot on the monitor, or the input section of the monitor.

    Let us know what you find.
  • AT5047

    The New AT5047 Premier Studio Microphone Purity Transformed

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice